The (remote) port number of the GTP module is configured during
initialization. It is therefore not required when calling
newGtpuCreateTunnel(), and could even lead to bugs (if another port
number is used than specified during GTP init).
This is a simple CU-UP load tester. It sets up a configurable number of UEs in the
CU-UP, then sends GTP traffic in downlink/uplink in the N3-F1/F1-N3
direction at the CU-UP. It then compares the sent and received data.
Additional parameters, such as amount of traffic, test length, packet
size, and IP addresses/ports are configurable.
To run:
mkdir build && cd build && cmake .. -GNinja && ninja nr-cuup nr-cuup-load-test params_libconfig
./tests/nr-cuup/nr-cuup-load-test
./nr-cuup -O ../tests/nr-cuup/load-test.conf
The tester should be able to detect lost and reordered packets.
Example lost: Receive order 2,3,5,6 (lost packet 4)
=> on packet 2, expected 2, next=expected+1=3
=> on packet 3, expected 3, next=expected+1=4
=> on packet 5, expected 4, diff=5-4=1 (lost 1), next=payload+1=6
=> on packet 6, expected 6
=> 1 lost
Example reordered: Receiver order 2,5,3,6 (lost packet 4)
=> on packet 2, expected 2, next=expected+1=3
=> on packet 5, expected 3, diff=5-3=2 (lost 2), next=payload+1=6
=> on packet 3, expected 6, (reduce lost by 1 to 1), next=expected=6
=> on packet 6, expected 6
=> 1 lost
Example reordered: Receiver order 2,5,3,4,6 (no losses)
